Decorative Column/Pilaster Wrap Material Calculator
Calculate the surface area of decorative wrap material needed to cover a round column.
Materials & Quantities
The outer skin, and the framing and fixings that hold it off the wall.

Lap and panel siding; fibre cement with its cutting waste and trim; EIFS from foam through mesh to finish coat; stucco in one and three coats with its control joints; rainscreen furring, ventilation area and fasteners; and the starter strips, corner posts and undersill trim that make up most of the small parts.
Whether the skin is drained or sealed. A rainscreen is estimated with its cavity, its furring and its ventilation openings; a face-sealed system is estimated as area, joint and sealant. Getting that wrong does not change the quantity by a little — it changes which items exist at all.
Glass and glazed units, which have their own family; the air barrier and insulation behind the cladding; and masonry veneer, which looks like cladding but is laid in courses.
26 calculators
Calculate the surface area of decorative wrap material needed to cover a round column.
Turn an elevation's net area into pails of EIFS finish and primer, using the coverage rate published for the aggregate grade you specified.
Calculate the adhesive needed to attach EIFS foam insulation board to the substrate.
Calculate the area of heavy-duty impact-resistant mesh needed at a building's high-impact ground-floor zone.
Calculate the EIFS foam insulation board thickness needed to achieve a target R-value.
Calculate the fiberglass reinforcing mesh needed for an EIFS base coat, including seam overlap.
Calculate how many rolls of fiberglass reinforcing mesh are needed for an EIFS wall, including seam overlap.
The sealant volume for the joints fiber-cement siding is caulked at, such as trim, corners and penetrations, from their total length and bead size.
Calculate the total corner post material needed for a fiber-cement siding installation's outside/inside corners.
Calculate fiber-cement siding material needed including its characteristic higher cutting waste factor.
Calculate the number of fiber-cement lap siding courses needed for a wall, based on the plank's exposed reveal height.
Derive fastener count and boxes for a lap-clad elevation from its own geometry — height, run, exposure and stud spacing.
Calculate the total fasteners needed for a rain-screen cladding panel installation.
Calculate the number and total length of vertical furring strips needed for a rain-screen cladding ventilation gap.
Calculate the net free (open) ventilation area for a rain-screen cladding system's perimeter vent gap.
Calculate the total nails or fasteners needed for a vinyl siding installation.
Calculate the J-channel trim needed around window and door openings and wall edges, with waste allowance.
Calculate the starter strip needed at the base of a vinyl siding installation, with waste allowance.
Calculate the undersill (utility) trim needed at the top of a siding run beneath the soffit, with waste allowance.
Calculate how many corner stone units are needed for a manufactured stone veneer wall's outside corners.
Calculate the scratch/setting-bed mortar volume needed for a manufactured stone veneer installation.
Calculate the weep screed needed at the base of a manufactured stone veneer wall, with waste allowance.
Calculate the total plaster volume and mass for a traditional 3-coat (scratch/brown/finish) stucco application.
Calculate how many control joints are needed within a tall stucco wall's vertical run to control cracking.
Calculate how many expansion joints are needed along a stucco or EIFS wall run within a maximum spacing.
Calculate the louver spacing needed to achieve a target solar cutoff (shading) angle.