SettingsSettings for this calculationUS
The total number of outside corners to be covered with corner units.
Count each outside corner of the wall that will use alternating long/short corner stone units rather than flat field stone.
The height of the wall at each corner.
Measure the full height of the corner to be covered, from the base to the top of the veneer.
The average vertical coverage of each alternating long/short corner unit.
Corner units are installed as alternating long and short pieces, which average out to a consistent linear coverage per unit along the corner's height — check your specific product's coverage data.
Corner units needed
62 corner units
- Total corner height to cover
- 40 ft
They open the calculator with your figures already in it
Manufactured Stone Veneer Corner Unit Calculator: 62 corner units — shown in imperial, US market. The link sets both, so the result they see is the one on your screen.
Show calculation logicHide calculation logic
How this was calculated
Formula source(s)
- Corner unit count = ceil((number of corners × wall height) ÷ average linear coverage per corner unit), since alternating long/short corner pieces average a consistent linear coverage per unit along the corner's height
Inputs used
- Number of Outside Corners
- 4
- Wall Height
- 10 ft
- Average Linear Coverage per Corner Unit
- 0.65 ft
Intermediate steps
- Total corner height to cover
- 40 ft
What this calculation does not cover
- Corner units are sold by the linear foot in cartons, not as loose pieces, so this figure has to be taken up to whole boxes before anything can be ordered — and corners are the pieces that break in transit and get cut down at the top course, with no allowance here for either. Manufactured stone is made in color batches too, and the carton fetched a fortnight later to finish a corner lands in a single vertical line where a mismatch is on show.
- Every linear foot of corner unit covers flat wall as well as corner: the long leg wraps roughly 150 to 200 mm (6 to 8 in) onto each face, commonly about 0.5 sq ft (0.05 m²) of flat coverage per linear foot of corner. That has to come off the field stone quantity, or the same area is bought twice — once as the expensive corner SKU and once as flats.
Estimated cost — your price
This site holds no price list for this material — local prices vary too much to publish honestly. Enter your supplier's price and the result is costed with it.
Computed in your browser — nothing you enter is uploaded. Presented in US customary units and US trade terminology. Where a formula follows a published standard, that standard and its edition are cited beside it on this page; where none governs, the page says so. Local amendments override model codes — verify against the code in force where you build.
Sources checked 2026-09-06 · in the site-wide review of 2026-09-06 · v1.0.1
Regulatory standards & verification citations1
- Corner unit count = ceil((number of corners × wall height) ÷ average linear coverage per corner unit), since alternating long/short corner pieces average a consistent linear coverage per unit along the corner's height
Cite this page
Your workspace
Most jobs need more than one number. Add the calculators you need next and they open right here, underneath this one — your figures stay on screen and nothing is lost to a page change.