From this site

One project, every trade

Each calculator adds its lines to a single estimate — consolidated BOM, schedule and cash-flow included.

Open My Project →

Floor Screed Cubic Yards to Tons Calculator

Convert a floor screed volume into short tons for ordering, haulage and storage planning.

Computed in your browser — nothing you enter is uploaded. Figures are presented for United States against IRC 2024, and every formula is cited under regulatory standards below.

Last verified 2026-08-26 · v1.0.0

Market
Imperial · sales tax

Approximate weight

19 short tons

High confidence

About 1.9 short tons per cubic yard for traditional sand-cement screed. A planning figure, not a specification. Confirm the density with your supplier before ordering by weight.

Conversion factor applied
1.9 short tons per cu yd

Screed volume follows from floor area and the specified thickness, and converting it to weight matters most on suspended floors where the added dead load has to be checked against the structure. Traditional sand-cement screed is heavy, and thickening it to correct an uneven substrate adds load that the original design may not have allowed for. Where thickness has to increase substantially, a lightweight or flowing screed is often the better answer than more of the same material.

Add the equipment this sizes

This result is a specification — 19 short tons — not a quantity. Put the thing it sizes into your project: how many, what you call it, and your supplier’s price.

Preliminary estimate, not certified engineering. This tool produces an indicative quantity calculation for planning purposes only — it is not a certified structural analysis, a guaranteed material takeoff, or a substitute for building department approval. Always verify measurements on-site and have a licensed contractor or structural engineer review any load-bearing, code-sensitive, or safety-critical work before purchasing materials or starting construction. Spotted an arithmetic or standards error? Report it to contact@craftquantities.com with your inputs — confirmed fixes become pinned regression tests.

[Schema Verified] Computed in alignment with American Concrete Institute (ACI 318-19) formulas and International Residential Code (IRC 2024) spatial boundaries.

Regulatory standards & verification citations

  • Typical bulk density used here: approximately 1.9 short tons per cubic yard
  • Density varies with moisture, grading and composition — the supplier's ticket weight governs

Your workspace

Most jobs need more than one number. Add the calculators you need next and they open right here, underneath this one — your figures stay on screen and nothing is lost to a page change.

Frequently asked questions

Does screed thickness matter structurally?
It matters both ways. Too thin and the screed cracks and debonds; too thick and the dead load may exceed what a suspended floor was designed for. Both ends have limits, and the specification sets them.
How long does screed take to dry?
Considerably longer than it takes to set. Traditional sand-cement screed needs an extended drying period before impermeable floorcoverings can be laid, and laying too early traps moisture and lifts the finish.
Is flowing screed different?
Yes — it is self-levelling, laid thinner, and dries faster than traditional screed. It costs more per volume and needs different preparation, but it often wins on programme and on load.