From this site

One project, every trade

Each calculator adds its lines to a single estimate — consolidated BOM, schedule and cash-flow included.

Open My Project →

Metal Roof Panel Calculator

Count standing-seam or corrugated panels for a roof slope, allowing for side laps and the ridge overlap.

Computed in your browser — nothing you enter is uploaded. Figures are presented in United States units and terminology, and each formula’s basis is cited under regulatory standards below.

Last verified 2026-08-26 · v1.0.0

Market
Imperial · sales tax
39 ft1.5 ft
Schematic, drawn to the proportions you entered — not to scale on screen.

Panels required

26 panels per slope

High confidence

Counts full-length panels on a rectangular slope. Ridge caps, eave and gable trims, closures and fixings are separate items.

Panel length required
16.5 ft
Total linear panel
429 ft
Slope area
643.5 ft²
Both slopes
52 panels
Coverage of the last panel used
0 ft

At the values currently entered, the panels required works out to 26 panels per slope. Figures are shown in United States units and terminology; switch the market above if you are building elsewhere.

Add the equipment this sizes

This result is a specification — 26 panels per slope — not a quantity. Put the thing it sizes into your project: how many, what you call it, and your supplier’s price.

Preliminary estimate, not certified engineering. This tool produces an indicative quantity calculation for planning purposes only — it is not a certified structural analysis, a guaranteed material takeoff, or a substitute for building department approval. Always verify measurements on-site and have a licensed contractor or structural engineer review any load-bearing, code-sensitive, or safety-critical work before purchasing materials or starting construction. Spotted an arithmetic or standards error? Report it to contact@craftquantities.com with your inputs — a confirmed fix gets a permanent check of its own, so the same mistake cannot come back.

Presented in US customary units and US trade terminology. Where a formula follows a published standard, that standard and its edition are cited beside it on this page; where none governs, the page says so. Local amendments override model codes — verify against the code in force where you build.

Regulatory standards & verification citations

  • Panel coverage width is the net width after the side lap, and is what manufacturers publish for ordering
  • MCA (Metal Construction Association) installation guidance: panels are run full length from eave to ridge wherever possible to avoid an end lap

Your workspace

Most jobs need more than one number. Add the calculators you need next and they open right here, underneath this one — your figures stay on screen and nothing is lost to a page change.

Still deciding? Metal Roof vs Shingles — the factors that actually differ, with no invented prices.

Frequently asked questions

Coverage width or panel width?
Always coverage. The overall width includes the part that disappears under the next panel's side lap. A 470 mm panel covering 457 mm is 3% narrower in use, and ordering against the overall width leaves the last run short on a wide roof.
Should panels run the full length of the slope?
Wherever the manufacturer's maximum length allows. An end lap is a detail that has to be sealed and fixed correctly, and it is the most common place a metal roof leaks. Long single panels also expand and contract as one piece, which is why the fixing method matters more as they get longer.
Does this include the ridge and trims?
No — panels only. Ridge caps, eave trim, gable or barge trim, valley flashing, closures and the correct fixings are separate and together are a substantial share of a metal roof's material cost.