From this site

One project, every trade

Each calculator adds its lines to a single estimate — consolidated BOM, schedule and cash-flow included.

Open My Project →

Curtain Wall Panel Count Calculator

Calculate how many unitized curtain wall panels are needed to cover a building facade.

Computed in your browser — nothing you enter is uploaded. Figures are presented in United States units and terminology, and each formula’s basis is cited under regulatory standards below.

Last verified 2026-08-26 · v1.0.0

Market
Imperial · sales tax

Curtain wall panels needed

84 panels

High confidence

Running these inputs gives 84 as the curtain wall panels needed. Currently reading for United States — pick a different market above and the figures re-cast accordingly.

Estimated cost — your price

This site holds no price list for this material — local prices vary too much to publish honestly. Enter your supplier's price and the result is costed with it.

Preliminary estimate, not certified engineering. This tool produces an indicative quantity calculation for planning purposes only — it is not a certified structural analysis, a guaranteed material takeoff, or a substitute for building department approval. Always verify measurements on-site and have a licensed contractor or structural engineer review any load-bearing, code-sensitive, or safety-critical work before purchasing materials or starting construction. Spotted an arithmetic or standards error? Report it to contact@craftquantities.com with your inputs — a confirmed fix gets a permanent check of its own, so the same mistake cannot come back.

Presented in US customary units and US trade terminology. Where a formula follows a published standard, that standard and its edition are cited beside it on this page; where none governs, the page says so. Local amendments override model codes — verify against the code in force where you build.

Regulatory standards & verification citations

  • Panel count = ceil(total facade area ÷ single panel area), the standard method for estimating unitized curtain wall panel quantities

Your workspace

Most jobs need more than one number. Add the calculators you need next and they open right here, underneath this one — your figures stay on screen and nothing is lost to a page change.

Frequently asked questions

Why is the panel count rounded up?
A partial panel cannot be manufactured or installed as a fraction of a unit, so the facade area is divided by the single panel area and rounded up (ceiling) to the next whole panel.
Does this account for corner units, custom-sized panels at building edges, or openings?
No — this estimates panel quantity from total facade area and a typical panel size only. Corner conditions, custom infill panels at edges/setbacks, and openings (louvers, doors) typically require custom-sized units that should be counted separately from the elevation drawings.
How do I determine my single panel area?
Multiply the panel's typical module width by its floor-to-floor (or panel) height, per your specific unitized curtain wall system design — for example, a 1.5m wide × 4m tall unit gives 6 m².